Installation
Our newest models no cutting needed.
|
Our newest models no cutting needed.
First: Remove Chrome rings around bulbs then remove Seal Beam lamps then Cut Aluminum Nest to a larger hole .
First: Remove Chrome rings around bulbs then remove Seal Beam lamps then Cut Aluminum Nest to a larger hole .
Second : Cut the Bucket (behind seal beams) Below Low Beam both sides to allow projector to fit newest models no cutting needed Our newest models no cutting needed.
Wiring
Connect: - Power Cable A to OEM Original Bulb Plug , Then into Ballast and into High Beam Flapper Plug on Low Beam Housing ,
Connect: the LED High Beam Bulb plug adapter in to OEM Plug
Wig Wag feature must be disabled and Reduced Voltage DRL Daytime Running Lights must be Disabled or use relay cable B Cable to attach to 12 vdc source , Ballast can't handle reduced voltage or pulsating voltage .
Connect: the LED High Beam Bulb plug adapter in to OEM Plug
Wig Wag feature must be disabled and Reduced Voltage DRL Daytime Running Lights must be Disabled or use relay cable B Cable to attach to 12 vdc source , Ballast can't handle reduced voltage or pulsating voltage .
Schematics A , A1 , B , C


RELAY for cable to supply full 12v to ballast if needed
Bruce Chandler
www.BrightHeadlights.com
377 Rubin Center Dr. Suite 115
Ft. Mill, SC. 29708-7257
704-523-3548 office
704-564-3383 cell
704-525-0221 fax
Bruce@Datasyst.net
Since 2001
www.BrightHeadlights.com
377 Rubin Center Dr. Suite 115
Ft. Mill, SC. 29708-7257
704-523-3548 office
704-564-3383 cell
704-525-0221 fax
Bruce@Datasyst.net
Since 2001